| 1.
PANEL TO PANEL ASSEMBLY |
|
|
| |
NOTE:
All panels and corner sections work on a Male/Female
assembly system. So using two Male sides or
two Female sides (of matching panels or corner
sections) will not work.
Don't leave Window
or Painted Panels for last, since they can't
be turned upside down.
Position panel at a 45°
angle then insert side of panel (1) into female
side of panel (2), as shown in diagram. Swing
panels into place. (see arrow) All support bars
should be facing the outside.
The door panel is the same
size as the wall panels and may be subsituted
for any wall panel throughout your sukkah.
If panels don't match up, turn one panel upside-down.
(there is no top or bottom to the panels) |
|
 |
|
|
| 2.
PANEL LOCK INSTALLATION |
|
|
| |
After each panel to panel connection is
made slide lock over outside flange of
panels to secure the panels in place
(see diagram)
NOTE: The lock is used to lock
the panels together and is not used in the corners.The
lock should be slid down to the panels first horizontal
rib.
To double secure both panels a 6" clamp is
placed on the top of the panels. (see diagram)
|
|
|
|
|
|
|
|
Hook female side of corner section into male side
of panel then swing in the direction of arrow
shown in diagram. NOTE:
The next panel is assembled to the male side
of the corner in a similar fashion.
Two half corners
should be left for last
|
|
 |
|
|
| 4.
ASSEMBLY OF LAST CORNER |
|
|
| (This
step is for 4-sided sukkahs only)
On a 4-sided Sukkah one corner must
be left for last.This last corner will use
the two half corner sections to join the
last two panels together.These two short corner
sections are to be slid into place, (not hooked)
starting at the top of the last corner and
sliding down.
NOTE: You may need a step-ladder
to see that you are sliding the corner sections
in properly. |
|
 |
|
|
| 5.
TOP OF SUKKAH WOOD BEAM ASSEMBLY |
|
|
| Place
2" x 3" lumber beams on the top
of the Sukkah, as shown in the
diagram.
NOW YOU CAN PUT ON
THE SCHACH AND YOUR SUKKAH IS COMPLETE.
|
|
 |
|
|
|
|
| Special
top “S” clamps have been provided
to give the side walls greater rigidity and
stability.
Slide wood bars into position
as shown in diagram.
|
|
 |
|
|
| 6.
FOR SUKKAHS WITH ONLY THREE WALLS |
|
|
| Attach
the two (2) Wall Support Brackets to wall
with screws.This can be a permanent installation.
Slide Sukkah panel into
bracket as shown in diagram. |
|
 |
|
|
